Whether you’re up against grease, sand, or ice, there’s a General nozzle that will cut through it. Some are designed for maximum penetrating power, some are designed to pressure wash the pipe walls, and some are designed to go around sharp bends. All of General’s nozzles are made of hardened stainless steel to last longer.

Make sure you leave the lines crystal clear with General’s rotary nozzles. The JN-RB heavy duty hardened stainless steel rotary nozzles have two 90 degree jets to scour the walls of the pipe, and two 35 degree jets to drive the hose down the line. The less expensive JN-RA hardened steel rotary nozzles have two 45 degree jets for combined thrust and cleaning action.

Rip through roots with the Chain Saw Nozzle. Lengths of chain can quickly and easily be switched for different diameter pipes. Spins at up to 10,000 RPM. 1/2" nozzle works well in combination with the 12 gpm Typhoon trailer jet to clear 4", 6", 8", and 10" lines. 3/8" nozzle is available in 4, 5.5 and 8 gpm models to clear 4", 6", and 8" lines.

High Performance Nozzles

General’s High Performance Nozzles for the Typhoon™ trailer jet incorporate patented fluid mechanics that significantly increases the thrust, pulling power, and cleaning power of the nozzles without needing to increase the water flow or pressure.

Other nozzles simply let the water churn around inside until it finds its way out the nearest orifice. High Performance Nozzles are custom machined to redirect the water through highly efficient inner surface channels directed toward each orifice. The nozzles have replaceable threaded inserts at each orifice, so when the nozzle wears, you only have to replace the inserts, not the whole nozzle. A set of insets are a fraction of the cost of a replacement nozzle.

Chisel Point Nozzle (Cat # JN-HP-151) is a good starting tool to loosen debris and sand to flush it from the pipe. It includes four forward jets and six rear jets. (The four forward jets are replaceable, the rear jets are not.)
Traction Nozzle (Cat # JN-HP-152) is ideal for blasting sand and mud from the line. It includes one jet forward and six jets to the rear. (All seven jets are replaceable)
Cleaning Nozzle (Cat # JN-HP-153) is used as a finishing tool to flush the line clean. It has all eight jets to the rear. (All jets are replaceable)

When you switch to General’s High Performance Nozzles you’ll get improved cleaning results, and you’ll typically use less fuel, man-hours, and water than other nozzles to get the job done. You’ll spend time "in the line" cleaning and less time refilling the water tank.